EDUCATIONAL TRAINING SYSTEMS

Model: MC-8051

8051 Microcontroller Trainer Kit

8051

FEATURES:

  • This is a LCD unit, with built in assembler and disassembler facility
  • 8051 Microcontroller operating at 10 MHz
  • 32KB powerful software monitor 27C256 EPROM
  • 256 bytes on chip RAM (partially used by Firmware)
  • Two 16 bit Programmable Timer
  • 32 Programmable I/O pins (24 from 8255 and 6 (P1.0 to P1.5) from Port 1 of 8031)
  • 50 Pin FRC connector for system bus expansion
  • 26 pin FRC connector for user interface from 8255
  • 9 Pin D type connector for RS 232C interface
  • 9 Pin D type connector for connecting to Power supply
  • Six different selectable baud rates from 150 to 9600
  • One timer and external interrupt
  • 101 PC type keyboard for entering user address/data and for commands
  • Built in line by line assembler and disassembler
  • Built in power supply
  • User-friendly software monitor for loading and executing programs with break point facility
  • Facility to connect to PC                                                                                   
  • Two numbers of 50 Pin Flat Ribbon Cable (FRC) duly terminated both sides with connectors.  These cables are necessary to conduct interface experiments.           

Interface Cards

  • 8bit AD / DA ConverterAlso used for Waveform Generation  
  • Stepper Motor Interface card                                                                            
  • 8255 Parallel Interface card                                                                             
  • 8253 Timer Interface card                                                                                 
  • 8251 USART (Serial) Interface card                                                               
  • 8279 Keyboard Display Interface card                                                           
  • 8259 Interrupt generation Interface card                                                        
  • 7-Segment display card                                                                                    
  • Traffic Light Experimental Module
  • This trainer includes built-in power supply, interface electronics, 12 LED’s simulate traffic signal (red, green, amber) for 4 directions, 28 LED’s simulate visual display for movement of traffic in each direction, 4 opto-electric (input) sensors used to simulate flow of traffic in each direction.
  • Power supply suitable for the above, this can be used for any one of the above interfaces at any time.

Accessories:

  • Computer simulated outputs and Step-By-Step detailed instructions are provided with the instruction manual.

logo footer